Additional Information
Due to the permanent and potentially destructive nature of soldering and connecting to other devices in general, always remember to test electronics first, before attempting to solder to them or connect any accessories.
For a flight controller, this can always be achieved by connecting to the board via USB and verifying that everything is working via the configurator. To test an ESC, you can power up the board via crocodile clips. We sell crocodile clips here for this very purpose.
Please see the Items requiring soldering section of our refund policy for more information.
Reward Points ⭐️
Description
The BLITZ F7 FC and 45A ESC Stack is iFlight's new high-quality flight stack, utilizing the very latest iFlight technologies with no expense spared on the components, bringing you the very best flight performance by the way of a new improved circuit design, better components, and overall a much lower electrical noise floor.
Flight Controller Top Features
- Improved circuit design, better components, and lower electrical noise!
- DJI HD VTX Connector (Plug-and-Play / No soldering required)
- FC indicator LEDs for visual debugging
- With LC filter
Specifications
- MCU: STM32 F722
- Gyro: BMI270
- Barometer: DPS310
- OSD Chip: AT7456E
- Flash: 32MB (Blackbox flash)
- UARTS: 6
- Motor outputs: 4x (SH1.0 connector)
- I2C serial: SDA / SLA pads
- Smart audio / IRC Tramp VTX protocol supported
- LED controller: Yes
- Beeper pad: Yes
- Firmware target: IFRC-IFLIGHT_BLITZ_F722
- Mount pattern: 30.5*30.5mm / 4mm PCB hole diameter
- Dimensions: 36.5*35 mm
- Weight: 7.8g
Wiring suggestions
- UART 1 for VTX HD / Analog
- UART 2 for a Receiver
- UART 3/4/5 for GPS or other sensors that require a serial port
- UART 6 for ESC Telemetry
Tips
- F722 MCU has an inner inverter.
- SBUS、CRSF、ELRS、IBUS、DSM ETC... can be connected to any unused UART_RX, we suggest you connect to Uart_RX2
- Frsky SmartPort, Tramp & Smart audio can be connected to any unused UART_TX, we suggest you connect to Uart_TX1
- F.port can be connected to any unused UART_TX, we suggest you connect to Uart_TX2
ESC Specifications
- Supports: DShot150/300/600/MultiShot/ OneShot etc.
- Mounting Holes: 30.5*30.5mm/Φ4mm
- Supports 2-6S lipo input
- Telemetry Output: NO
- Target: QH-40 16.7
- Current sensor: Yes
- Constant: 45 Amps
- Current rate: 200
- Burst: 55 Amps
- Weight: 14.7g
- MCU: BB21
- BEC: NO
Package includes
- 1PC X BLITZ F7 V1.1 FLIGHT CONTROLLER
- 1PC X BLITZ E45S 4-IN-1 45A 2-6S ESC
- 1SET X SILICONE GROMMETS
- 1SET X WIRE HARNESS FOR F7 FLIGHT CONTROLLER
Product Details
| Product Type | Flight Controller |
| Shipping Weight | 100 grams |
| Vendor | iFlight |
Found it cheaper elsewhere?
Get in touch and we'll price match it for you 👌. Terms and conditions apply.
Customer Reviews
Did you know that you could earn 50 reward points for every product review left and an additional 25 points for also adding a photo? Learn more.
Support Information
Further product support information: https://iflightrc.freshdesk.com/support/home